Slayer007 Rotor Less Pulse Motor—– My Replication
This is a replication of the Slayer007Rotor Less Pulse Motor. The design is a charging circuit that uses a reed switch and a magnet to trigger a coil, diode, and transistor into self oscillation….
143 Search results
For the term "pulse magnetizer circuits schematic".
QMU Controller rev2.0e RUNNING PULSE MOTOR GENERATOR
Quanta Magnetics final revision 2.0e pulse motor microcontroller RUNS PULSE MOTOR GENERATORS with precision control. Available NOW at Quanta Magnetics.com.
Pulse Motors: MHOP Driver Development # 8: Waveforms, Schematics
Here I demonstrate the Drain and Sense Coil waveforms and explain what the setpoint control does. Schematics are included at the end of the video. This MileHigh Operational Amplifier w/ Auto-Strobe is a very…
Slayer Exciter runs pulse motor out of water glass.ASF
This is Slayer’s Exciter running a pulse motor off a glass of water. This experiment is based on the work of Dr. Stiffler and videos of his SEC experiments. Energy comes out of the…
Dally replication 8 200V pulse
Finally a nice sharp 200V / 70ns pulse, so ready for activating the DSRD diodes and hunt for the 1ns/1Kv/1Khz pulse. Forum: www.overunity.com
Pulse Motor – 10 minute run – no power in
A bizarre event just now. The pulse motor is based on the same one as my last video…ultra simple transistor switch, to coil, to rotor, back EMF caught by a 1F capacitor through a…
sMartCreations self start solar pulse motor
This is a light powered pulse motor that self starts. The circuit is from sMartCreations2010 here at Youtube. He took a Solarbotics solar pendulum circuit and turned it into a pulse motor circuit. I…
Bedini Hydrate Crystal Cell—powering a pulse motor and PENNY
This shows the Bedini Hydrate Crystal Cell that I made powering a pulse motor —and “Penny”. “Penny” is powewed by energy collected from a pickup coil I call “Maggie. The pulse motor setup shown…
PULSE MOTOR WITH RECYCLED MATERIALS
This pulse motor was made with RECYCLED MATERIALS of other old projects…! I am using a BEDINI CIRCUIT with two transistors, 2N3055 AND MPS 2222A, the coil is BIFILAR and is my new experimental…
Dally replication 12 (new diodes, new pulse record 1000V)
After receiving my Russian KD226D diodes and experimenting with severall capacitor combinations, i found i could reach the 1Kv pulse at 14nS using a 119nS pulse from the nano-pulser. Just need to clean up…