Paper clip electric motor
This is simple DC electric motor that uses paper clips for the shaft and bearing supports. The paper clips form part of the circuit. The shaft paper clip is slighty bent at one end…
Experiments, inventions, patents, …
This is simple DC electric motor that uses paper clips for the shaft and bearing supports. The paper clips form part of the circuit. The shaft paper clip is slighty bent at one end…
After struggling with dodgy meter readings for good solid power input figures within previous experiments, I decided to ditch the use of batteries altogether ! A stepper motor is used, 2 wires of which…
rcm.amazon.com used Cylinder magnet with radial polarisation for this experiment. other good magnets :Ball magnets: rcm.amazon.com or: rcm.amazon.com other good magnets: Cylinder rod magnets rcm.amazon.com Strong magnets rcm.amazon.com rcm.amazon.com rcm.amazon.com Cube magnets rcm.amazon.com Video…
A scrappy quick build…results of which to be taken forward for the FanGen project and others. The rotor is made from the bearing and now bladeless innards of a 12V PC fan. It was…
This is the “Tiny Orbo Replication” ver.3. Ver.1 was tested at far above 100% efficiency. See globalfreeenergy.info Ver.3 is not complete yet. Only 1 toroid. Needs 16 toroids. Everything is taped down for now. It’s still under construction. Input power…
Input: ~ 180 mW total. 170 mW of that 180 mW is joule heating from electrical wire resistance, thus leaving 10 mW for the motor. Output: ~ 280 mW from one pick up coil. Also, Ive taken a guesstimate that the heat produced by this motor due to bearing a…
This is my little induction coil light “Maggie” turned into an intergal part of a pulse motor / generator arrangement. Her little paper clip arms are holding a shaft mounted spinning neo magnet that…
Hi all After the good finger feeling from my previous video, i decided to become independant of subjectivness, and redo my test bench to get more precise results. So i mounted my 2 weights…
THE MAGNETIC ROTOR CONSIST IN EIGHT NEODYMIUM MAGNETS, THE ROTOR IS TURNING IN A VERY THIN SHAFT OF STAINLESS STEEL, THE SHAFT IS A NEEDLE. THE OBJETIVE OF THIS ROTOR IS THE DEVELOPMENT OF…
This is my MAGNETIC LEVITATION BASE that consist in A STEEL SHAFT, no magnetic steel, and this shaft has two small cilinders in the end of both sides, and two NEODIMIUM RINGS IN TWO…