172 Search results
Don Smith Device Project Part 6: Ferromagnetic core, high wind primary, very interesting :)
lights even brighter & better sparks coming off L-2 🙂
Don Smith Device Project Part10: SYSTEM ON FULL BLAST @ approx 400-1000% efficiency??
so lets say minimum the output is 48VDC x 20A (assuming correct) = 960wa​tts …Input is 110VAC x 2A = 220watts …960w / 220w = 4.36 ( 436 % efficient ) …BUT…if the voltage…
Don Smith Device Project Part 8: SYSTEM ON HIGH, STEADY 12-20 AMPS NO CAPACITORS
Trying to get it all on one board for portability. will try a dc setup soon Adding HF now will kick some serious ass voltmeters are destroyed, only have amp measurements & analog meters…
Don Smith Device Project Part 9: SYSTEM ON LOW, Average 1.7 Amp In, 10+AMPS Out :)
SYSTEM TURNED DOWN LOW, (which can be observed by comparing my last vid) –(wierd, No visible transmission on the second s-gap?) This vid demonstrates 1.5 Amp In, 10 Amps+ Out, plus measured the ground…
Don Smith Device Project Part 13: B&W Inductor Coils :D
New coils are in! havent worked on resonance yet other than making L1 slightly lighter than L2… so that i should only need to work inwards on L2 ??:)
Don Smith Device Project Part 16: 30 volts input & FULL brightness? :)
this is an older vid i decided to post because of the incredible performance these capacitors exhibited. 10000V pulse .005uf. Since this vid i have killed two of them 🙁 but their performance was…
Don Smith Device Project part 17: NST measurement
HA can you believe it, 60 hz?!? What a joke, this is going to be amazing when i get a high freq NST!!!
Don Smith Device Project Part 18: self-oscillating bedini ignition
experimental setup using a car ignition coil & bedini in self-oscillation.