Don Smith Device Project Part 13: B&W Inductor Coils :D
by F.E.N. · Published · Updated
New coils are in! havent worked on resonance yet other than making L1 slightly lighter than L2… so that i should only need to work inwards on L2 ??:)
Related posts:
- Don Smith Device Project Part 26: Extra Inductor Added, Built-In Radiant Antenna? made an observation while looking at Destine2012’s Dynatron design, a...
- Don Smith Device Project Part 32: Stepdown Coil Tune and Resonance at 53Khz im back, properly tuning the stepdown coils using the LEDs...
- Don Smith Device Project Part 15: New Schematic, Center Tap, Output Capacitors, & Diodes Working :D Now virtually identical connections as Don Smith’s board...
- Don Smith Device Project Part 21: New coils CW CW and Primary Series LC Tank, Overall Improvement ? Added some new B&W 2408TL coils and .005uf caps courtesy...
- Don Smith Device Project Part 6: Ferromagnetic core, high wind primary, very interesting :) lights even brighter & better sparks coming off L-2 🙂...
- Don Smith Device Project Part 29: Ionization Was Stealing Power, problem solved i was noticing a sound from inside L1, and it...
- Don Smith Device Project Part 19: New Driver with L1 Tank Circuit Testing out my new Variable Power and Variable Freq driver...
- 39A Don Smith Device Project: Incorporating Heins Bi-Toroid Technology hello all, im looking for a good transformer… this seemed...
- Don Smith Device Project Part 34B: Test the Tuning of Part A Very pleased with the results here, i really didnt think...
- Don Smith Device Project Part 22: THE Answer To Direction of Windings, go WITH the induced polarity Same current as before, added two more lights, even better...