Free Energy Project – Driver Motor Input Test
Donations to help support and speed up my open source Free Energy Project can be made here: www.paypal.com I did the test in this particular way so that you can see what’s happening more clearly, even without the amp/voltage input measurements from the motor. The coils provide a good push to the wheel even at that relatively low rpm test speed…estimated to be 300 rpm…but that’s a conservative estimate and the actual rpm is most likely lower than that :)) I didn’t let it rev right up to the top end because I just fixed the darn thing again today…lol…I’ll let it rip tomorrow…after a few more tests 😉 Hopefully more and more people see that with more coil sets, this thing will drive itself. Eventually I will need conventional coil configs on it as well, with a load, to slow it down…just like Ed did with his bottles wound with wire 😉 The driver motor could then become a generator. And this thing is made from scraps…anyone can do it! I have given this idea away to everyone :)) Please use it. There are also many other applications for the technology as I mentioned in my first vids in this series.