Looper — Ridin The Rails

by · Published · Updated

This is LaserSaber’s SJR Looper V4.0 built up on a small wooden board. Two pieces of heavy gauge brass wire were put into the board to form the (+) and (-) power rails. The circuit was then built up on top the rails. I got this idea from TinselKoala here at YouTube. It makes for a clean layout for this particular circuit. Replacement of components parts is also easy.

Related posts:

  1. TinselKoala’s ‘MescalMotor’— my replication running This my replication of TinselKoala’s ‘MescalMotor’ running. This is an...
  2. Perpendupetulum Pulse Motor This shows a pulse motor using the “Perpendupetulum” driver circuit...
  3. Looper Tester —- with no magnet rotor This is my ‘Looper Tester’ running in self oscillatoin with...
  4. Chilliqueen high voltage circuit using camera parts.ASF This is a replication of Chiilqueen’s high voltage inverter circuit...
  5. Steam Engine —- Learning Tool This is a non working wooden model of an oscillating...
  6. LED oscillator made from parts out of a CFL.ASF This is a replication of Slider’s and Iluzyin’s “choke” Led...
  7. TinselKoala’s ‘MescalMotor’ — a partial replication This shows a partial replication of a project by TinselKoala...
  8. Part 1. Filament Spooling oscillator – Russ’s Helix Looper: The Idea Filament Spooling oscillator – Russ’s Helix Looper, Part 1: The...
  9. Newman On A Stick This shows a little homemade electric motor called a ‘Newman...
  10. Energy capture using a simple resonant tank circuit This shows a simple resonant tank circuit being used to...

You may also like...

Follow:

More