Peltier module charging without hot or cold
This is a Peltier module charging a capacitor in a way other than with just hot and cold.
Experiments, inventions, patents, …
This is a Peltier module charging a capacitor in a way other than with just hot and cold.
Video how to produce some Copper-Sulfide inside a glas tube with 2 graphite pencil rods as the end conductors to get a thermoelectric effect. Unfortunately one can not see, what the exact voltage is, that this guy gets, when he heats one end with his s…
Next video is a bit better: watch?v=0Z-pcI9ycWY I made an AC/DC receiver and put it inside a peanut butter jar. The AC output lights an incandescent bulb as usual. The DC output from the…
If the gas outlet is closed off and the pressure allowed to force the water out of the white chamber, the buoyancy of the module will increase and it will float upwards. If the…
A 400 watt Peltier module is shown here picking up energy from a 2″ toroid coil used in the Slayer007 low voltage CFL Joule Thief circuit. The energy is captured in a 10uf 35…
I am using a LM386N audio amplifier to build a simple homemade AM radio. I use an air gap capacitor and a homemade coil for the tuning circuit. The tuning circuit basically filters out…
.This shows my homemade rechargeable AA powering a one AA LED flashlight. The amp draw is very high on this flashlight and my homemade AA can only power it for a short time. It…
This shows a simple homemade battery running a simple homemade inverter. This setup was built specifically for running the new 110v AC led lightbulbs.
This generator use a 12 volt 60W Peltier heat / cooling element, which deliver voltage from 0.5 to 2,5 volts, being heated on one side 90 degrees and cooled on the other to 30…
This is an ugly homemade 6v Lead / Alum battery—-but it is very strong and it can do magic. The electrostatic device that it is powering is a Slayer Exciter type that I call…