Don Smith Device Project Part 3: Amp Measurement
by F.E.N. · Published · Updated
This beast destroyed my 1000 voltmeters, so all i have is a clampmeter. Read a solid 5 Amps,
Related posts:
- Don Smith Device Project Part 2: Kilo-Watt Generator fried both my 1000 volt multimeters, replaced the fuses…& they...
- Don Smith Device Project Part 8: SYSTEM ON HIGH, STEADY 12-20 AMPS NO CAPACITORS Trying to get it all on one board for portability....
- Don Smith Device Project Part 30 B: Amp Measurement and Testing took this vid to have proof that this was running,...
- Don Smith Device Project Part 9: SYSTEM ON LOW, Average 1.7 Amp In, 10+AMPS Out :) SYSTEM TURNED DOWN LOW, (which can be observed by comparing...
- Don Smith Device Project Part10: SYSTEM ON FULL BLAST @ approx 400-1000% efficiency?? so lets say minimum the output is 48VDC x 20A...
- Don Smith Device Project part 17: NST measurement HA can you believe it, 60 hz?!? What a joke,...
- Don Smith Device Project Part 19 C: New Driver with L1 and L2 Tank Circuits Complete Completed the Tank circuit for both L1 and L2, the...
- Don Smith Device Project Part 33: full watt bulb vs Smith stepdown comparison Hi everyone, just comparing again the system vs the full...
- Don Smith Device Project Part 4: Light Bulb Killer :) LOL finally got a vid of me burning out my...
- Don Smith Device Project Part 35: Resonant 60hz Transformer Experiment :) High freq driver temporarily down, so i wanted to try...