tesla boiling water experiment1.wmv
Hi all Thank’s “Blue Serge at energerticforum”” who made very clear schematics and explanation of his experiments, i could not prevent me to make some testing. This is my first experiment on a Tesla Airpin system (or approaching the airpin system, named by a contributor named Karl which is a well known experimenter in this research) and so the results I tried and fried a lot of light bulb and i finally decided to test a boiling WATER experiment I hope you can hear my voice because the spark gap is so noisy that it coverS everything hope this helps and good luck at all Laurenr.. Some technical data NST (neon sign transformer ) rated 220 AC input 0.75 A for 6000 volt sine wave (or square ?) that is + 3000 / – 3000 volts. Due to the diodes , i suppose i use only one part of the sine wave that is 3000 volts. The spark gap is copper and adjustable which is very important, because when i open ( make the gap bigger ), the input wattage decrease on the wattmeter ??? As you can see the wattmeter indicate only about 8 watt total input power. the cap bank is made with 12 serial 1000 volt 0033 uF, that is 12 kv at about 0.002 uf. i have 2 of those bank. the diode are taken from a micro wave oven and are rated probably around 12 kv each. the heating element is also taken from a micro wave oven . this is the the grill heating. I cut about 5 cm length in order to get about 5 ohms resistance The water in the plate is pure tapwater without any additiv. The smoke is probably steam. If i …