Earth Battery Lights 200 LEDs
This is my earth battery-joule thief-supercaps lighting 200 leds. The video did not turn out so good. It looks foggy to me. It looked much better in real life but, oh well. I am…
Tagged: free power
Earth Battery-Joule Thief Runs 48 Inch Tube (40 watts)
This is my earth battery running a 48″ (40 watt) florescent tube. It is not at full brightness but it is lit and lit pretty well. It is much brighter than it appears on…
15 Watt Tube Powered by Earth Battery!!
This is a 15 watt 18 inch long tube illuminated by my modified Fuji Joule Thief circuit powered by my earth battery. The light was better than I expected. I am also using two…
Earth Battery Lights 100 LEDs
This is my earth battery illuminating 100 leds! I am using 2 supercaps (2.3 volt, 10 Farad each) in parallel with the earth battery to my modified Fuji Joule Thief circuit. This is connected…
Earth Battery Joule Thief Lights 7 LEDs
This is my earth battery powering a joule thief circuit and running 7 ultra bright, 10mm, 28500 MCD LEDs. I misspoke myself in the last video, these are 28500 MCD not 28000 like I…
Earth Battery Joule Thief LEDs Experiments
This is my new and improved earth battery running 4 ultra bright 10mm 28000 MCD LEDs. I am using a standard Joule Thief circuit wound (bifilar) on a ferrite toroid this time. An N3904…
No Bearing Bedini IV
A quick video to show one of my straight spinning very stable egg magnets sent to me from overseas by a good friend of mine. For more information go to overunitydotcom in Jonnydavro’s No…
Earth Battery Joule Thief Experiments
This is just a quick video of my new earth battery set-up. I am using the same 2 carbon rods but this time, on the minus side, I am using a large block of…
No Bearing Bedini Motor III
Just a short experiment to see if I could get a cylindrical neo magnet to spin on the No Bearing Bedini set-up and it turns out I can. Learn more at Overunitydotcom in Jonnydavro’s…
No Bearing Bedini II
My 2nd attempt here. I am using a 12 volt battery here as my 9 needs recharging. I tried a flat platform and it stays in the center better and I can crank it…