Earth Battery-Joule Thief Runs 48 Inch Tube (40 watts)
This is my earth battery running a 48″ (40 watt) florescent tube. It is not at full brightness but it is lit and lit pretty well. It is much brighter than it appears on…
Experiments, inventions, patents, …
This is my earth battery running a 48″ (40 watt) florescent tube. It is not at full brightness but it is lit and lit pretty well. It is much brighter than it appears on…
This is my earth battery powering a joule thief circuit and running 7 ultra bright, 10mm, 28500 MCD LEDs. I misspoke myself in the last video, these are 28500 MCD not 28000 like I…
A quick video to show one of my straight spinning very stable egg magnets sent to me from overseas by a good friend of mine. For more information go to overunitydotcom in Jonnydavro’s No…
This is just a quick video of my new earth battery set-up. I am using the same 2 carbon rods but this time, on the minus side, I am using a large block of…
Just a short experiment to see if I could get a cylindrical neo magnet to spin on the No Bearing Bedini set-up and it turns out I can. Learn more at Overunitydotcom in Jonnydavro’s…
My 2nd attempt here. I am using a 12 volt battery here as my 9 needs recharging. I tried a flat platform and it stays in the center better and I can crank it…
This is my replication attempt at Jonnydavro’s No Bearing Bedini Motor. I am using the standard 3055 transistor and the regular Bedini set-up. For the coil, I once again am using Lidmotor’s transformer coil….
This was a very creative answer to the question I asked in my last video. The question was, how to pulse the AA battery to keep the supercaps charged enough to light the ultraviolet…
This is a quick video response to some questions I have been getting about how fast it might be turning. the thig I find interesting is that, I am using a 470 ohm resistor…
A quick update on my Bedini replication. This has been running a long time now. It has been on for most of 2 days. No more fried pots (so far) and it just hums…