Pulse Motors: MileHigh OpAmp Comparator Driver Development #3

by · Published · Updated

Success! The rotor and frame/axle assemby is pressed into improvised service to test the Pulse Motor Driver by MileHigh.

It seems to like to go about 1300 RPM, which is decent, considering the sticks, straw and mud construction.

Related posts:

  1. Pulse Motors: MileHigh OpAmp Comparator Driver Development #1 MileHigh’s suggested op-amp comparator sense circuit for pulse motor driving...
  2. Pulse Motors: MileHigh OpAmp Comparator Driver Development #2 I’ve added a 0.1 uF bypass cap on the power...
  3. Multi- Frequency Pulse Driver—AKA the NOISE MAKER.ASF This my latest quest towards effiiciency in a pulse motor...
  4. Arduino: Developing a Pulse Motor Driver Using Edge Detection I’m starting to develop a generalized driver for Pulse Motors...
  5. Pulse Motors: MagSpinner 1 Test RPM Run I was inspired to build a little magnet spinner by...
  6. Wireless Power and High Voltage: Wirelessly driven flyback driver making HV arc Here I’ve just taken the Wireless Inductive Power Transfer system...
  7. Prototype pulse motor with prop An extension of the tiny pulse motor posted yesterday –...
  8. Pulse Motors: MagSpinner 1: Input Power Measurements Here I show an input power measurment on the MagSpinner...
  9. jt “pulse motors driver” Single coil reed switch Adams motor and bifilar coil transistor...
  10. Pulse Motors: MHOP #5, Waveforms By Request Showing op-amp output, that is mosfet Gate waveform and the...

You may also like...

Follow:

More