Free Energy Project – EdiniGen

Poor Ed, everyone forgets him. Donations to help speed my progress are very much appreciated 🙂 I share everything: www.paypal.com Watch the shaft of the wheel and notice the rpms…under 500 rpm is my estimation. Finally I’m at a point where I can start winding coils. And incidently, coils can be made to perform much better than the ones shown here….MORE Wire!…HAHA!!! I’m going to wind another heavy gauge set of coils and put them on the Ed side to show what happens in my next vid…I really need to do that again. I need to do that before I buy wire…need to work out which size is best. In his writings Ed said that with his PMH setup, you will have all the electricity you need. And he said that the only problem will be in how to use it all. This is precisely the case here with my setup because you must USE the electricity to get the positive effect on the wheel…inverse Lenz effect (or whatever?)…free energy :)) There you go, free energy is right under your nose…can you smell it? I can friggin taste it now!…hehe I forgot one of the main points I wanted to bring up, about Bedini motor magnet configuration. A bedini wheel/motor will also work if your magnets are positioned on the wheel with alternating poles facing out…interesting stuff 😉 In this vid the magnets were all N facing out on the Bedini driver (prime mover) side. Maybe for the next vid I’ll alternate them to show it. I’m not sure if there’s a difference, but very close to the same performance as

You may also like...