Tiny Orbo Replication 3
This is the “Tiny Orbo Replication” ver.3. Ver.1 was tested at far above 100% efficiency. See globalfreeenergy.info Ver.3 is not complete yet. Only 1 toroid. Needs 16 toroids. Everything is taped down for now. It’s still under construction. Input power is ~ 0.12 watts. Nearly 100% is joule heating (wasted heat), & does not go to powering the motor. Max rpm was 13500, where the motor was still rapidly accelerating, but something went wrong. It began to rapidly decelerate. Decades of experience tells me without any doubt this motor is far beyond 100% efficiency. Congratulations Sean & Steorn! In this video you’ll see the motor run, but first some footage while it was being made. Warning, it’s loud. I have no idea why. The bearing is a good new ceramic bearing. The meter shows frequency, not rpm.Multiply it by 7.5 to get rpm. 1.4KHz = 10500 rpm. This toroid is very special. It’s Metglas MAGAMP, perm=1 million, but the large plastic case was removed. Core was then Epoxied. After the core was wound, the perm changed to nearly an air core caused by pressure, which is a well known effect. This effect seems to greatly amplify the excess energy effect, turning the motor into a monster. Even though the perm nearly = a vacuum, the toroids work great for this design. Sean, you did it brother!!! I am not affiliated with Steorn. Orbo is trademarked by Steorn, steorn.com. You can find daily blogs about my replication progress at http