This is my earth battery running a 48″ (40 watt) florescent tube. It is not at full brightness but it is lit and lit pretty well. It is much brighter than it appears on the camera. i am using my…
This is a 15 watt 18 inch long tube illuminated by my modified Fuji Joule Thief circuit powered by my earth battery. The light was better than I expected. I am also using two 2.3 volt 10 Farad supercaps in…
This is my earth battery illuminating 100 leds! I am using 2 supercaps (2.3 volt, 10 Farad each) in parallel with the earth battery to my modified Fuji Joule Thief circuit. This is connected to a string of 100 white…
This is my earth battery powering a joule thief circuit and running 7 ultra bright, 10mm, 28500 MCD LEDs. I misspoke myself in the last video, these are 28500 MCD not 28000 like I stated. It is good to get…
This is my new and improved earth battery running 4 ultra bright 10mm 28000 MCD LEDs. I am using a standard Joule Thief circuit wound (bifilar) on a ferrite toroid this time. An N3904 transistor, 1k resistor and a 2.3…
This is just a quick video of my new earth battery set-up. I am using the same 2 carbon rods but this time, on the minus side, I am using a large block of magnesium. (5 pounds) The carbon is…
Just a short experiment to see if I could get a cylindrical neo magnet to spin on the No Bearing Bedini set-up and it turns out I can. Learn more at Overunitydotcom in Jonnydavro’s No Bearing One Magnet Bedini Motor…
This is a quick video response to some questions I have been getting about how fast it might be turning. the thig I find interesting is that, I am using a 470 ohm resistor to the transistor base. In series…
I charged a 2.3 volt 10 Farad supercap with an AA battery for several seconds and hooked the cap to my modified Fuji circuit and powered it to illuminate 100 leds. No batteries included, just a single supercap. More on Overunitydotcom in the Joule Thie…
This is two Joule Pirates (Joule Thieves) wired in parallel running off of one AA battery powering a 48″ tube. (40 watts) The funny thing is that the tube is brighter with just one circuit turned on than with my single circuit experiments from before. …