Free Energy News » Joule

Joule Thief very very low input 0136 volt

F.E.N. — Fri, 23 Dec 2011 14:33:45 +0000

This Joule Thief work at a very very low input voltage from 0.125 to 0.35 volts and the output voltage is 2.7 volts, to the LED. An ordinary Joule Thief work down to 0.6 to 0.8 volts, because of losses in the transsistor. Voltage ratio is 1 to 21. So if the LED need 5 mAmps, the battery must give over 100 mAmps.

Joule Thief Shorted.10 times more light.

F.E.N. — Thu, 22 Dec 2011 15:56:54 +0000

This joule thief works much better when the ferrite core is shorted with a wire – a magnet or a capacitor. I adjust the trim capacitor for the best resonance. The magnet must be adjusted in strength. Here are 9 pieces best. Try it on other jouel thief and they oscillate much better. 10 times more light on LEDs.

Oil cell still working after 4 + months. Plus crystal cell update.

F.E.N. — Thu, 24 Nov 2011 13:32:30 +0000

Quick update.

Incoming search terms:

long lasting joule thief

Crystal Cell Magnet Motor. Running for over two weeks and still going!

F.E.N. — Wed, 02 Nov 2011 21:51:13 +0000

Crystal Cell was made with: Borax – Epsom Salt — Alum – Salt Substitute.

Super Joule Ringer! Part 2

F.E.N. — Thu, 27 Oct 2011 22:58:19 +0000

More info + link to schematic @ laserhacker.com

Super Joule Ringer! Lights my workshop 24/7.

F.E.N. — Fri, 26 Aug 2011 17:30:55 +0000

This is my first practicable application of the Joule Ringer design. This has very real world value to me. LaserHacker.com for more info.

Incoming search terms:

Super Joule Ringer!, don smith magnetic generator, jouleringer

Oil cell long term test run update.

F.E.N. — Tue, 23 Aug 2011 19:56:59 +0000

This test run was started on 7-21-2011.

How to build the "Laser Saber" air battery.

F.E.N. — Tue, 23 Aug 2011 19:42:56 +0000

Plus info on the oil based long life cells.

Incoming search terms:

free energy joule thief running common bulbs, lasersaber air battery, pricip energie kapanadze

Steven E. Jones / Joule Ringer / Update

F.E.N. — Tue, 05 Jul 2011 15:31:40 +0000

Just a few updates on a side project I have been woring on.

Visit at Per Johan in Sweden to work on the Prof. Jones circuit

F.E.N. — Sun, 26 Jun 2011 21:08:55 +0000

www.overunity.com Visit at Per-Johan in Abod Öglunda Sweden to work on the Prof. Jones circuit.. I just stopped by Per-Johan´s place on my vaccation trip to say hello, as I was near him and he was very friendly and showed me his Prof. Jones circuit he was working on. Then we tweaked it all a bit and got the battery to charge up while running it lights the LED. Look at the circuit diagram in the video. We used 4 x 1N4148 diodes o´for the FWBR diodes, but with better diodes this would work even better. We also tried to selfloop it via a capacitor instead of the battery, but we only had an hour of time to play with it at my visit, so there were too many losses and also the 2 x 1 Ohm resistors were still in there, so the pickup coil with the bridge puts out less current than it consumes, but due to the voltage spikes the battery does charge indeed a bit up during runtime of the circuit. Other conclusions could not be drawn in the short time of the visit. Many thanks to Per-Johan for the friendly hospitality and the nice talks we had. Regards, Stefan.