Free Energy News » Joule Thief

Physicist Steven E. Jones shows overunity circuit and measurements (2 of 2)

F.E.N. — Fri, 27 May 2011 12:37:42 +0000

On May 26, 2011, Dr. Steven E. Jones demonstrated a simple solid state circuit he has been working on that produces more than eight times more energy out than is electrically put in, implying that energy is being harvested freely from the environment somehow. He shows the results he has gotten both from his oscilloscope as well as a high-end Techtronics oscilloscope he used at Brigham Young University where he served as a Professor. The plans for this circuit are posted at a story we’ve posted at PESN. pesn.com Video shot by Sterling D. Allan.

Incoming search terms:

@energy com ph loc:CZ, bedini self charging motor, car hho circuit diagrams, Hho Generator Plans

Physicist Steven E. Jones shows 8x overunity circuit and measurements (1 of 2)

F.E.N. — Thu, 26 May 2011 23:09:26 +0000

Joule Thief Fuji Twin Bulb Light.wmv

F.E.N. — Sat, 09 Apr 2011 05:19:15 +0000

This is a simple adaptation of the modified Fuji JT circuit and 2 Lights of America led bulbs. Each bulb has 27 chip leds and this is being run on an AA battery. For more info, go to overunitydotcom. Thanks to JosePino for the use of his circuit diagrams and photos…also thanks to Jesus from OUdotcom for the group photo. Note: Cut the anode end of the diode by the transistor to get the full wave. This is not on Jose’s schematic.

MiniFuji Joule Thief LED Lights.wmv

F.E.N. — Tue, 05 Apr 2011 08:07:48 +0000

This is a continuation of my work on the MiniFuji circuit and the Light Of America LED lights. Each LOA bulb (designed to operate on 120 volts grid power) has 27 chip LEDs and here I am lighting two of them from one MiniFuji circuit. I am working on a smaller version of this circuit and I will use that in the second light. There is a lot of light from these bulbs on a single AA battery. For more info go to Overunity.com in the Joule Thief topic area. Thanks for watching.

Portable MiniFuji.wmv

F.E.N. — Thu, 31 Mar 2011 05:50:56 +0000

This is a smaller form of the modified Fuji Joule Thief circuit that I made to be portable. I can use this on various devices as it is held on with small neos and also uses my universal neo battery connectors and alligator clips. In this video I show it lighting a Lights Of America led bulb and a jug light I made using 200 leds. Very easy and cheap to make and very useful and handy to have around. For more information go to Overunity.com in the Joule Thief topic area. Caution: There is high voltage in these circuits, do not replicate or play around with these unless you know what you are doing. No electronic animals were injured during the building of this device.

Joule Thief Door Lock Indicator.wmv

F.E.N. — Sun, 24 Oct 2010 23:17:44 +0000

This is a simple device I made for my Mom, who is having memory problems and can’t remember if she locked her front door or not. She can see this from where she sleeps and if she wakes up and sees the red LED, it means her door is locked and she can go back to sleep. Just a basic JT circuit using a 1″ ferrite bead instead of a toroid, 22 ga. bifilar windings, 2N3904 transistor and a 1k resistor. I modded a simple reed switch which is activated by 2 neo mags I hotglued to the lock knob. I used a very small red LED because she leaves this on almost 24 hours/day because her door is locked almost all the time. So far, in a month, I have only had to swap “dead” batteries once. Pretty good run time. For more info: Overunitydotcom.

Joule Thief – enhanced

F.E.N. — Sat, 30 Jan 2010 21:18:54 +0000

The Joule thief. Simple enhancement, creates a huge energy gain. Just use the back EMF.

Joule Thief Pirate Light

F.E.N. — Wed, 13 Jan 2010 07:01:20 +0000

This is a simple light fixture made using a modified Fuji circuit Joule Thief and a disposable plastic food container. It lights up an 18″ tube pretty well and this is very easy to read by. It throws light 360 degrees around the room and works well. I was planning on using another Jeanna light circuit I made but I must have a short somewhere so I stuck in the Fuji. I will use the new circuit on another light project when I get it fixed. For more information go to Overunity.com in the many joule thief topics. Thanks for watching.

Incoming search terms:

joule thief circuit

LED Diffusion Experiments.wmv

F.E.N. — Mon, 28 Dec 2009 00:26:48 +0000

This is a video of some experiments using 2 identical 10mm ultrabright LEDs where I sand the end and then sides of one and compare it to our control LED. Jeanna, over at Overunity.com was interested in this as we are looking for a good diffuser system for our LEDs that we use on our Joule Thief circuits. for more information, go to Overunity.com. Thank you, Bill

Pirate’s Lidmotor Jeanna Light Joule Thief Replication.wmv

F.E.N. — Sun, 13 Dec 2009 08:39:35 +0000

This is my replication of Lidmotor’s Jeanna Light using Jeanna’s large toroid Joule thief design and Lidmotor’s circuit. This circuit puts out between 1200-2000 volts! I do not have an exact measurement yet. (I am afraid of frying my measuring equipment!) This uses two 3-3/8″OD ferrite toroids, TIP 3055 transistor, 20 ohm rheostat, 15 turn variable 1k resistor, and 28 ga. magnet wire for the secondary and pick-up coils. I used solid copper 22 ga. wire for the primary. The cfl is a 40 watt equivalent rated at 9 watts. In the video, I am running from a 1.4 volt C cell but, I have run this on an AAA and an AA and a D cell as well using my magnetic universal battery holder idea. For more information, go to overunity.com in the joule thief topics area. This is a lot of light and it lasts a long time and you can use dead batteries that others would have tossed out to power this. More to come using this circuit. Please use caution if replicating this, or any other high voltage output circuit. If you don’t know what you are doing, get someone who does to help you or don’t do it. (Legal Disclaimer) Thank you for watching. Bill