Light bulb is a levitating yet powered lightbulb. It will float stably in midair and remain on for years without any physical contact, charging, or batteries. Ironically, with the levitation and wireless power circuitry both on, this entire package still consumes less than half the power of an incandescent bulb. The bulb and the casing contain hidden circuitry that uses electromagnetic feedback to levitate the bulb roughly 2.5″ from the ne…
Hi all very busy this last time So i try to concentrate on some very important phenomena, before going further in my research. So this weird coupling between the Kacher and the incandescent Bulb is amazing. How is it possible that an incandescent filament (designed for a DC current ) can wake up and lit in a shortcircuited steel loop.??? How does the interraction between the Kacher exciter and the loop interfer, to provide the current to light t…
This Quick Update shows that the Regenerative Acceleration Effect also is taking place for normal Resistive Loads. In This case I have used a 15W/240V Rated Incandescent Light Bulb as a Load. Which in this demo runs on approximately 2W on 88Volts. We can get the Resistance of this Light Bulb by: P/U=I so: 15W/240V=0.0625AR=U/I=240V/0.0625=3840 Ohms So to be more precise: The Power P going to this Incandescent Light Bulb in this Experiment is: P=…
This is a 15 watt 18 inch long tube illuminated by my modified Fuji Joule Thief circuit powered by my earth battery. The light was better than I expected. I am also using two 2.3 volt 10 Farad supercaps in parallel with the Joule Thief Fuji circuit. For more info go to Overunitydotcom in our Joule Thief topic. Thank you for watching. Bill …
Here a new test of the 2SGen v1.0 powered WITH and WITHOUT the neodymium magnet… The magnet is required to get the effect at the output. More info at: www.jlnlab.com …
I charged a 2.3 volt 10 Farad supercap with an AA battery for several seconds and hooked the cap to my modified Fuji circuit and powered it to illuminate 100 leds. No batteries included, just a single supercap. More on Overunitydotcom in the Joule Thief topic area. Thank you. …
This video is to show that the shematic posted and youtubed (than retired) by Sem 77 (delamorto) works fine. Contrary to my previous video, this time it is not plasma, but the bulb is really lit and became very hot, as with ” standard ” electricity. Of course the bulb is far from beeing fully lit, but it surely consume some watts. A previous estimation is that the circuit and the blower consume about 1.4 A at 12 volt. When i connect …
This is a simple adaptation of the modified Fuji JT circuit and 2 Lights of America led bulbs. Each bulb has 27 chip leds and this is being run on an AA battery. For more info, go to overunitydotcom. Thanks to JosePino for the use of his circuit diagrams and photos…also thanks to Jesus from OUdotcom for the group photo. Note: Cut the anode end of the diode by the transistor to get the full wave. This is not on Jose’s schematic. …
Coils are not yet in resonance, but getting excellent results. Wanted to show the before picture… Experimenting with different combinations of capacitors & wiring arrangements. Primary is at the moment 100 winds of 12 gauge wire, L2 is going to the load. Powering a series of TEN, 12volt dc switches which can each handle 30 amps, and after that, i put about 10 Amps to an incandecent bulb to light it up BRIGHT & also keep warm …
www.overunity.com JAPANESE WATER CAR FUEL CELL INTERNALS …
11 August 2007 at 08:04 · Comment
·
·
