Pan oscillator running 110 volt LED light.ASF
This is Jonnydavro’s pan oscillator running a standard 110v /20 LED candelabra bulb. In this video I am using a 12 volt battery with a rheostat to control the power. Two small transistors are…
95 Search results
For the term "como se hace un volt draw".
Steorn Orbo Rep. 6 New Trigger.
When the Buz 71 goes ON. The volt over D — S is only 0,05 volt. A transistor has about 1,5 volt and 2 transistors have 3 volt. This give 3 volt losses to…
Light Multiplier—Amp draw measurements.ASF
This is the second video on my ‘Light Multiplier’ showing the amp draw with and without the oscillator driving the neo magnet rotor. It is of interest because the amp draw is actually less…
Steorn Orbo Rep. 8 without 9 volt batt.
Now the motor can run from 330 – 1000 Rpm. on the 9,1 volt trigger coil supply and without the big cap. on 22000 yF. But only when I use a 1,25 volt 10000…
Joule Thief. Amazing Hand Heat Energy. 0,1 volt part 3
A Peltier element delivers a small voltage up to 2 volts, when it is cooled on one side and heated on the other. Heat from my hand gives only 0.1 to 0.2 volts. I…
3 volt Bug Zapper– TESLA COIL
This is a simple traditional Tesla Coil using a 3 volt electronic bug zapper and a few other easy to make parts. There are several other videos here on Youtube on how to build…
6 volt air battery! Very easy to make.
This is an air battery test experiment I have had running for the last few weeks. The outer masking tape is just to hold the magnesium ribbon in place. The battery works fine without…
Joule Thief Solar Cell 0,5 volt part 2
Note, that the Leds are connected between Collektor and Basic. It gives much more light in the LEDs. Works fine at 0,5 volts in and out 3,6 volts 2 X 2 red Leds. Normally…
Joule Thief very very low input 0136 volt
This Joule Thief work at a very very low input voltage from 0.125 to 0.35 volts and the output voltage is 2.7 volts, to the LED. An ordinary Joule Thief work down to 0.6…
One Magnet Bedini 2. 5 volt 10 milliamp
With Jonnydavro’s help I was able to get the amp draw way down and sitll run this on 2.5 volts. I also stabilized the spinning magnet so it runs smoother now.
