imageshack.us hehe back again, couldnt resist adding bulbs, now there is 12 watts of light in PARALLEL to the output, series connection is not as stable. This is very promising. it reads 0 amps (prob Microamps) under full load. BUT…
1 May 2012 at 23:56 · Comment
·
·
here im just showing how long it can run on 5x 5F caps (1 Farad) at 12.5 volts, similar to how a joule ringer will self-oscillate untill the caps run down, except there is no need for any other components,…
1 May 2012 at 08:52 · Comment
·
·
Back with this sweet little circuit, and have settled with a straight stepdown to load, extra grounding via the air can give more light, but the pancakes seem to feedback to oneanother and raise current draw..ever so slightly, but it…
1 May 2012 at 08:15 · Comment
·
·
The purpose of the experiments is to verify the use of antennas and how much energy can be harvested from their use compared to the circuit alone with out them. Anyone know about antennas and why they help so much…
30 April 2012 at 08:41 · Comment
·
·
i re-built my previous radiant oscillator circuit to observe the difference between HV to load, and stepping down to load, it seems stepping down before load is best, the bulb is a 12 v 1.2 WATT bulb BUT… WHAT IS…
30 April 2012 at 07:52 · Comment
·
·
lasersaber’s oscillator; base of transistor triggered from negative side of circuit; very good finding, laser, thank you for sharing… Incoming search terms:rotoverter форум
29 April 2012 at 04:08 · Comment
·
·
Hi all Trying hard to catch what is going on in this stuff, i experiment a lot of things. So i tried to understand why the Car coil with the INDUCTRET connection works, So i imagined that the high voltage…
28 April 2012 at 23:02 · Comment
·
·
This is a very different config see the schematic at: laserhacker.com Incoming search terms:joule thief pwm hho 2n3055, свободная энергия torus
27 April 2012 at 20:25 · Comment
·
·
wanted to show you all something special, i went back to the center-tap, based on Dynatrons work, and used a Caduceus winding for L1. Due to the center being the negative now, L1 needed to be shortened using the 1/4…
27 April 2012 at 09:32 · Comment
·
·
