Push Pin Pulse Motor

by · Published · Updated

This shows a pulse motor rotor design using a plastic jar lid, 6 magnets, and two common push pins. No glue was needed. Why did the motor run much better when I used a certain capacitor?

That’s right you guessed it.

Say hello to my little friend. 🙂

Again!!!

6F 2.7v super capacitor

Pre – charged with 2v

Solar panel slowed down the discharge

Related posts:

  1. Plastic Jar & Needle Pulse Motor This is a pulse motor made from a small plastic...
  2. Maggie and the Pill Bottle Motor This shows my ‘Pill Bottle Electric Motor’ doing work. My...
  3. Super Capacitor Bedini SSG Lid motor This is my latest SSG. Its a low voltage design...
  4. Compact Pulse Motor Drive Unit This shows an electric pulse motor drive unit that has...
  5. EZ Spin 10 hour runner This is to document an unusually long run time of...
  6. Door Alarm Coil pulse motor This is a homemade electronic pulse motor that uses a...
  7. Electrostatic Motor —- Running On A Capacitor This is a small ‘electrostatic motor’ running on energy stored...
  8. Motor – Generator running on a capacitor Here is a simple “Motor – Generator” that is using...
  9. Motor Generator—- how it works This is how the ‘Motor Generator’ from my last video...
  10. Capacitor Pulse Motor & Maggie This is a little “window” type pulse motor running on...

You may also like...

Follow:

More