DIY – Building A Hotend From Scratch… ( Heater Too) Testing Ideas For The OSD……

by · Published · Updated

hey guys, I’m building a Hotend from scratch. testing some ideas for new hotend(s) for the OSD…

using some Peek, Stainless Steal, NiCr wire, and what ever else i have laying around i made a new hotend…

conclusion is that it works fine, but i need to try to keep the heater on the tip more… else its working good!

live footage real time here:

GodBless
~Russ Gries
rwgresearch.com

Related posts:

  1. DIY – Building A Hotend From Scratch… ( Heater Too) Testing Ideas For The OSD…… hey guys, I’m building a Hotend from scratch. testing some...
  2. TPU Extensive Torture / Strength Testing & Temperature Tests. Smash stuff! non Scientific Testing TPU Extensive Torture / Strength Testing And Temperature Tests. Lets...
  3. Burn Rate Testing With HGG Corona Dish Charge Air Ionizing. More Testing Needed. I need to do more tests on this one. The...
  4. P4 Stanly Meyers Quenching Disk , Russ’s Assembly Of His Quenching Disk Set Up. RWGresearch.com .025″ around 60 microns and .0015 is about 30 microns...
  5. Update 23 NGE Papp: More Balloon Testing & The Search For Feedback Current. Update 23 NGE Papp: More Balloon Testing & The Search...
  6. Speed Testing The New Extruder Gantry Setup On My Delta Rostock 3D Printer Speed Testing The New Extruder Gantry Setup On My Delta...
  7. 3D Printing:Taulman 618 Nylon Strength Testing, Smash It, Hammer It, Bend it, Manny Temperatures. 3D Printing:Taulman 618 Nylon Strength Testing, Smash It, Hammer It,...
  8. Water heater after math… Haha, pipe broke off… Well it wet really well. Only took about 4 hrs...
  9. Test:9.0 Magnetizing Experiments : Testing Shielding Materials Test:9.0 Magnetizing Experiments : Testing Shielding Materials In this test...
  10. FAIL! What Happens When You Have A Mechanical Failure On A 24Hr 3D Print? Luckily i did not have to find out what 24...

You may also like...

Follow:

More