Pulse Motors: MescalMotor Cleanup

by · Published · Updated

Just a short clip; working on cleaning up the mounting and getting consistent behavior. No, it’s not “light powered”… yet! Running on -12 – 0 – +12 vdc here, drawing around 40 mA.

Related posts:

  1. Pulse Motors: MescalMotor Horizontal Mounting As you see. I made a horizontal mount for the...
  2. Pulse Motors: MescalMotor First Light: Push-Pull 741 Pulse Motor Many thanks to subscriber m3sca1 who first suggested this basic...
  3. Running a pulse motor on infrared light.ASF This shows my little light powered self-start pulse motor running...
  4. Pulse Motors: PerPenduPetulum 3: PingPong Bob The PerPenduPetulum light-powered pendulum, with a Ping-Pong ball as the...
  5. Pulse Motors: MileHigh OpAmp Comparator Driver Development #2 I’ve added a 0.1 uF bypass cap on the power...
  6. Pulse Motors: Supplement: TK MiniPulse Stress Test BC337 Here’s the BC337 being pushed to its limit. It’s over...
  7. Pulse Motors: MHOP #4 Development: LED Autostrobe Requirements WARNING: Strobe and FLICKER! If you are sensitive to flicker...
  8. Pulse Motors: MileHigh OpAmp Comparator Driver Development #1 MileHigh’s suggested op-amp comparator sense circuit for pulse motor driving...
  9. Pulse Motors: MHOP #11: Some Instrumental Data with Load Here I show the effect on the input power measurement...
  10. Pulse Motors: Using the SNOT to Demonstrate a "True Experiment" A true experiment is a system where a researcher varies...

You may also like...

Follow:

More