Pulse Motors: Supplement: TK MiniPulse Stress Test BC337

by · Published · Updated

Here’s the BC337 being pushed to its limit. It’s over 100 degrees C, by the “hot iron” moist finger test. Still working well. I am amaze.

Related posts:

  1. Pulse Motors: Supplement: TK MiniPulse Reed: How Low Can You Go? WARNING: Stroboscope flashing in use. Please don’t watch if you...
  2. Pulse Motors: MagSpinner 1: Input Power Measurements Here I show an input power measurment on the MagSpinner...
  3. Pulse Motors: TK MiniPulse Intro, Overview, RPM ...
  4. Pulse Motors: TK MiniPulse II: Low Voltage Operation I swapped the mosfet for a bipolar transistor and made...
  5. Pulse Motors: TK MiniPulse III: Reed Switch Driver, Lights NE-2 I discovered that the little reed relay will respond well...
  6. Electric OU: Tar Baby / NERD Circuit MOSFET Stress Test The IRFPG50 is one tough transistor. Erratum: The duty cycle...
  7. Pulse Motors: MHOP #7: Dwell and Timing Strobes Video Test Here’s a test video to see if the LED strobes...
  8. Pulse Motors: MagSpinner 1 Test RPM Run I was inspired to build a little magnet spinner by...
  9. Pulse Motors: MileHigh OpAmp Comparator Driver Development #3 Success! The rotor and frame/axle assemby is pressed into improvised...
  10. Pulse Motors: MileHigh OpAmp Comparator Driver Development #2 I’ve added a 0.1 uF bypass cap on the power...

You may also like...

Follow:

More