Pulse Motors: TK MiniPulse II: Low Voltage Operation

by · Published · Updated

I swapped the mosfet for a bipolar transistor and made the motor run down to under 2.5 volts input.

Please see the previous video for the schematic, and this video for a list of the minor changes.

Thanks for watching!

Related posts:

  1. Pulse Motors: Supplement: TK MiniPulse Reed: How Low Can You Go? WARNING: Stroboscope flashing in use. Please don’t watch if you...
  2. Pulse Motors: TK MiniPulse III: Reed Switch Driver, Lights NE-2 I discovered that the little reed relay will respond well...
  3. Pulse Motors: TK MiniPulse Intro, Overview, RPM ...
  4. Extreme High Voltage: SassyClassE SSTC: Overview and Demonstration I dusted off the SassyClassE sstc for some experimentation, so...
  5. Extreme High Voltage: SassyClassE SSTC: Overview and Demonstration I dusted off the SassyClassE sstc for some experimentation, so...
  6. Extreme High Voltage: SassyClassE SSTC: Overview and Demonstration I dusted off the SassyClassE sstc for some experimentation, so...
  7. Pulse Motors: MHOP #5, Waveforms By Request Showing op-amp output, that is mosfet Gate waveform and the...
  8. Pulse Motors: MHOP #11: Some Instrumental Data with Load Here I show the effect on the input power measurement...
  9. Minnie Low-Voltage Cutoff Circuit Test Developing and testing the Minnie LiPo Low Voltage Cutoff circuit....
  10. Pulse Motors: Supplement: TK MiniPulse Stress Test BC337 Here’s the BC337 being pushed to its limit. It’s over...

You may also like...

Follow:

More