Arduino: Developing a Pulse Motor Driver Using Edge Detection

by · Published · Updated

I’m starting to develop a generalized driver for Pulse Motors using the Arduino OSEPP Uno clone.

Here I’ve gotten the sensor input system programmed into the unit, and I show its function and serial monitor output.

The program sketch so far is at
http://www.mediafire.com/?fbwun5jbndbec4b

Related posts:

  1. Arduino 6: TKPhotovoltaic Sensor, Use of Serial Monitor, Sensor Range Mapping By suggestion, I hooked a simple PV cell to the...
  2. Arduino 4: TKVoltmeter, Potentiometer LED Sweep, Circuit Controller Here I use the example sketch called “arrays” and blended...
  3. Arduino 9: Driving a Bipolar Transistor: 2n3055 As Light Dimmer Another application of the simple, sensor driven voltmeter. The 2n3055...
  4. Arduino 14: Induction Meter using Parallax LCD and KA393 Comparator Here’s a small and easy inductance meter made from the...
  5. Arduino 13: TK SousDuino PID Crockpot Controller "First Bite" The system is now in usable form. The PID system...
  6. Arduino 16: Magnetic Levitator Optically Controlled Here’s the latest project, an optically-controlled magnetic levitator using the...
  7. Scoposcopy: Supplement: Arduino’s Method of Inductance Measurement To complement the earlier video on inductance measurement by resonating...
  8. The Arduino Pulsed Motor Controller (APMC) v1.0 tested on the Adams type motor The APMC (Arduino Pulsed Motor Controller) v1.0 is a very...
  9. Arduino 10: Basic Feedback Loop, Homeostasis, Maintaining a Setpoint Now I’ve set up the system to maintain a set...
  10. Arduino 5: TKThermosensor w/ Alarm, Airflow Sensor I used the same circuit arrangement as in the last...

You may also like...

Follow:

More