Split Gapped Coils
I wondered what would happen if a wireless system coil was split into separate pieces. Rather than 1 full coil, as in the Lasersaber SJR 3.0 say, separated coils with clear extensive gapping may produce different running properties. Indeed, if the gap is to close, the circuit can be difficult to start up or may shut off with a load applied. Too far distant and many of the close proximity induction wireless effects are lost. At a ‘Goldilocks’ point, there is a spike and the LED’s between coils will brighten suddenly. That distance is shown as the placement setting of these coils. Each coil has a layer of clear tape between the 2 winds, which, may function as a capacitance dielectric, but at least protected the layers from any scrubbing and shorting during construction. A coil shorting method of such a system of coils may bring this into line with the Don Smith thread at Energetic Forum. Or, indeed, a separate much larger primary coil being placed beside the magnetics flux path of the individual coils. With each section being part of the whole and yet displaying here individual capabilities, it raises thoughts on such techniques. Many thanks to CTOL1 for sending me some diffused white LED’s, which in my opinion give a nice warm glow to the midway sections. The coils they sit on are simply 56uH inductors with the LED’s straight to the pins, as first seen in one of Iluzyon1’s videos. Datasheet for the salvaged D1506 transistor used in this video : alltransistors.com As usual …