generador Figuera approach 2
Hi all my next step in the “Figuera generador ” experiment. So after the rotating commutator, i tried a solid state system based on the Arduino microcontroller to see if i could get better results. The test shows that with the kindly offered by “Wonju” software, i got almost the same scope trace as per the rotative mecanical commutator. Than i tried to modify the value of the resistors to see if it could change the voltage curve, and got not so much results, until i made a wrong connection and noticed that the middle resistor was wrong connected, and the trace was very little distorted. Than i disconnected the 2 neighbour resistor and the trace looked even more and more as a SQUARED wave but very interestingly right in the Middle of the cycle and without any flyback Spike ??? So i desconnected all the resistor and kept only the 2 exrtrem connections on the Arduino output pins. And here the result. So it seems that the current trace under no load is shifted on the right of the voltage trace, which is normal for a transformer, but than when i load the secondary ( i can also apply a dead short ) the current wave trace does not align back under the voltage trace as it should do. ?? Very intersting isn’it ?? Of course discussion at EF under the thread “reinventing the wheel ” by Wonju Youp i just forget to mention a important info ,that this technology is probably also related to Thane Heins bitorroid transformer ( BITT ) and now we have also the chance to share experiment …
