accelerating rotor under load 1.wmv
Hyep !! i am very happy to finally get the acceleration under load that we spoke of in different thread at OU or EF or heretical builders etc. This one is based on Thane Heinz basic system and inspired by Overunityguide video. I got a PVC drum of 12.5 cm diameter on which i glued 16 neo mag ( rectangle magnet 20/ 10 / 2 mm , N42 ) evenly and alternating N/S. The coil is bifilar (0.3 mm copper wire ) and i don’t know the number of turns but as shown on the bolt core it is 37.5 ohms DC resistance (not so high impedance ) and 139 mH inductance. The terminals of the bificoil are connected in serie. At the beginning the voltage is at 11 volt on the prime mover, to get more than the threshold speed which is around 2000 rpm. The core is a 12 mm diameter bolt of standard steel. (8.8 quality ) I am very estonished of the strong acceleration when i shortcut the coil above the threshold. But i am also estonished that under the threshold where i do not get the acceleration but where i get deceleration with the LED load, i can get an acceleration when i shortcut the coil. ?? So it seems that the LOAD is determining the level of the threshold. Very intersting indeed OK discussion at OU in the “Delayed lenz ” thread. Hope this helps Good luck at all Laurent
