Joule Thief Muller Dynamo

by · Published · Updated

This is my Muller Dynamo testing unit using two paralleled Joule Thief circuits as drivers. Instead of using the standard Joule Thief coil I simple used the paired up diver coils on the Muller. This arrangement runs on very low power only. I did this to experiment to try out a different way to run the dynamo besides the Hall sensor circuit.

Related posts:

  1. Hand held walk around Muller Dynamo—toy.ASF This is what my Muller Dynamo project ended up as....
  2. Muller Dynamo driven by a SEC 18 exciter.ASF This is my Muller Dynamo being powered by a “one...
  3. Muller Dynamo with electronic circuit.ASF This shows my Muller with a Hall sensor electronic circuit....
  4. JT Muller Dynamo scope shots.ASF This shows the generator output signal on my Joule Thief...
  5. Ambient solar energy Muller Dynamo.ASF This video is for “Slider”. He was curious if you...
  6. Humidity Battery and a Tanked Joule Thief.ASF This shows a battery that uses calcium cloride to draw...
  7. my Muller Dynamo with all the coils.ASF This is my Muller Dynamo running with all the coils...
  8. Muller Dynamo— my kitchen table learning tool.ASF This shows a simple “Muller Dynamo” type device that I...
  9. Stirling Engine & Muller Dynamo— Hybrid This shows a Stirling Engine & a Muller Dynamo joined...
  10. Muller Dynamo– generator coil shorting test.ASF This a generator coil shorting test using my Muller Dynamo....

You may also like...

Follow:

More