onepulse bouncer test 2.wmv
This setup is made to better understand the power of a pendulum. To do this i use a pendulum made of magnet stack which are also the motor magnet. Than a coil (air core and very thin) gives the push to the rotor to overcome the small distance to complete the 360 degree from the original free fall rotation. So if i let the rotor free falling from 12 oclok, it will swing up to about 10 oclock, and than go back until stop. But if i can chop the rotor at 10 oclock (at the end of the up swing ) and give him the slight push to pass the 12 oclok ,than it will goes on for a next rotation.. By doing this , for a very low power input i can get the complete rotation of the heavy pendulum. This pendulum get very strong centrifugal force (especially near the bottom swing) before going up to 10 oclock by inertial force, And the question is HOW TO USE THE CENTRIFUGAL FORCE OF THE BOTTOM SIDE OF THE SWING here some experiment but we can do MUCH better good luck at all Laurent
