King Kong Bedini Wheel

by · Published · Updated

Correction: The CFL that I used was powered by 2 of those little rechargable battery banks wired in parallel not in series…so the ignition coil was receiving 14.4volts. I used a circuit with 2x2n3055 transistors to create a pulse. Also, I should have mentioned that the magnets on one wheel face N and the other wheel they face S out. I’m thinking of making 2 more coils for the wheel (another tower) to make a total of 8.

Related posts:

  1. Bedini Motor vs Flynn Motor So, I’m going to be making a couple of new...
  2. Bedini Energizer – 6 Coiler 18 more coils to go! I have to build a...
  3. Bedini Wheel – 7 Coiler – Plus Generator Setup I forgot that I wanted to say that I stuck...
  4. Bedini Wheel – 7 Coiler – Plus Generator Output I still want to try the ThaneCHeins setup. I forgot...
  5. Bedini – Eccentric Pickup Coil – Lenz Effect Reduced I forgot to mention that the eccentric coil is 34...
  6. Bedini Energizer – 6 Coiler – New Wheel Setup Bedini says that you can use 25% of the torque...
  7. Bedini Leedskalnin 3 Coil – Good Voltage I’m going to add 3 more coils…but had to share...
  8. Bedini – Coil Resistance / Efficiency Using this single battery circuit, I am starting to wonder...
  9. Bedini 6 coiler A few hopefully interesting differences have been built into this...
  10. Bedini – Leedskalnin Update — Connecting The Flux I got the idea of connecting the flux paths from...

You may also like...

Follow:

More